Rear diff crossmember mount bushings
Join the discussion
Recommended Reading
-
Engine hesitation after ignition coil recall service
General Maintenance & TroubleshootingHi...about a month ago I had the recall service that replaced the ignition coil. I've noticed since then that there is some sluggishness/hesitation when accelerating. Have a 2019 2.0L with 6-speed manual. Anyone else had this issue? I'm interesting in finding out others' experiences...- 7
- 349
-
rfh928 · updated
-
Wheel hub bearing and axle nut torque specs
General Maintenance & TroubleshootingHello all, I'm in the process of changing my 2014 XV limited's rear wheel bearing hubs again(this is the 2nd time in 90,000 miles :mad:). Thankfully they were easy to pry out. Does anyone know the torque specs for the 4 hub bolts and the axle nut? I haven't been able to find them online. Thanks!- 4
- 3K
-
Changing PCV valve on 2018 Crosstrek
General Maintenance & Troubleshootinganyone done this? I assume its pretty easy and will cost me a lot less than the $85 the dealer wants to do it.- 6
- 161
-
AC Compressor
General Maintenance & TroubleshootingLooking for some advice I guess for when I go to the dealer later this week. I had my engine taken out in late December to repair an oil pan leak. It was winter, so I had no need to use my AC. When it finally started to warm up enough to use the AC in early March, I realized the AC would not...- 15
- 5K
-
Turkeytoe · updated
-
Shaking idle
General Maintenance & TroubleshootingI have a 2015 Crosstrek limited, and I notice that after I wash the car it has a rough shaking idle when ever it is at a idle. It does not matter wether the car is in drive or park and the A/C is not on when this happens and it does not effect it when it is on. Any ideas, I’m guessing it might...- 3
- 150
Join now to ask and comment!